Grass Valley iMC-Panel-100 v.7.2.9.0 - Manual (Page 163)

151
iMC-Panel-100
Operator’s Guide (for Imagestore 750s)
IP Address
Follow these steps to change the panel’s IP address:
1 From the main menu, press ‘Panel Settings’ to display the ‘Panel Info’ menu. Then press ‘IP
Setup’.
2 Press ‘Change IP’ to display the ‘IP address’ sub-menu. Use the keypads to enter or change
the IP address.
3 Press ‘Change Mask’ to display the ‘Subnet Mask’ sub-menu. Use the keypads to enter or
change the subnet mask.
4 Press ‘Change GW IP’ to display the ‘Gateway IP address’ sub-menu. Use the keypads to enter
or change the IP address.
5 In the keypad menu, press ‘Done’ to save the new IP address or press ‘Cancel’ to discard it. If
you press ‘Done’, the menu will display a message that you must restart the panel to activate
the new IP address: Press ‘OK’ in the alert to proceed. Press ‘Cancel’ to leave the IP address
unchanged.
S Changing the IP address incorrectly can result in an inoperable system, although the
problem can be corrected easily. This is usually the responsibility of the system administrator
and done once and rarely thereafter.