Enabling master control on the itx channel config – Grass Valley iTX Master Control v.2.3 User Manual
Page 20
iTX-MC User Guide
2-10
iTX-MC system configuration
Enabling master control on the iTX Channel Config
For each of the iTX channels associated with an Imagestore 750 (master control enabled),
you must specify the Imagestore 750’s IP address in the Master Control property on
channel’s iTX Channel Config. The Master Control property allows the iTX Desktop’s Mixer
Mapper component to communicate directly with the Imagestore 750 associated with the
iTX channel.
1.
Open the iTX Desktop’s Engineering View and select the Channel Config tab.
2.
Select the channel that is associated with the Imagestore 750 and then the Channel tab.
3.
Select the Channel Config 4 tab and specify the IP address of the Imagestore 750 in
the Master Control setting’s IP address field.
4.
Repeat steps 2 and 3 for each of the master control enabled channels and then click
Close.