Grass Valley K2 Summit 3G v.9.0 - Manual (Page 67)

9. On the Disk Selection page, select Disk 1 and then click Next .
NOTE: Verify capacity to make sure you select the boot media card.
10. On the Next Selection page, select Yes, I want to restore another partition or hard disk drive and
then click Next .
11. On the Partition or Disk to Restore page, select (C:) and then click Next .
12. On the Restored Partitions Resizing page, select Yes, I want to resize partitions and then click
Next .
13. On the Restored Location page, select (C:) and then click Next .
NOTE: Verify capacity to make sure you select the boot media card (CompactFlash or mSATA)
and not a media drive. The boot media has a much smaller capacity and has an interface
identified as "IDE (0) Primary Master".
14. On the Restored Partition Type page, select Active and then click Next .
15. Do one of the following:
• If the Restored Partition Size page does not appear. Skip ahead to the Next Selection page.
• If the Restored Partition Size page appears. Continue with the next step.
16. On the Restored Partition Size page, do one of the following:
• If Free space after reports 0 bytes, leave settings as they are. Click Next .
• If Free space after does not report 0 bytes, increase Partition size until Free space after reports
0 bytes. Click Next .
17. On the Next Selection page, select No, I do not and then click Next .
18. On the Restoration Options page, do not make any selections. Click Next .
19. On the “…ready to proceed…” page, verify that you are restoring the correct image to the correct
location. Click Proceed .
20. On the Operation Progress page, observe the progress report.
21. When a message appears indicating a successful recovery, click OK .
22. Click Operations | Exit to exit the Acronis True Image program.
The machine restarts automatically.
23. Remove the recovery media while the machine is shutting down.
24. When prompted, enter the machine name.
Make sure the name is identical to the name it previously had.
At first start up after reimage, the system is in Embedded Security Update mode by default.
Depending on whether you restored from a system-specific image or from a generic image, refer to
the appropriate disk image recovery task for next steps.
14 November 2012 K2 Summit 3G Service Manual 67
Service procedures