Extreme Networks Sentriant AG200 - Manual (Page 15)

Sentriant AG200 Hardware Installation Guide 15
Connecting Power
Connect the AC power cable from the power connector on the back of the Sentriant AG appliance to an
active power outlet.
To power on the Sentriant AG appliance, press the power switch to the On position.
When the server has completed the boot process, the LCD panel displays the following information:
● Hostname of the appliance
● IP address of the appliance
● Software version
● Product name
● System uptime
If a terminal is attached to the console port, a system prompt is displayed.
Connecting Cables
The details of connecting the Ethernet ports vary depending on the type of deployment. Deployment
types using the Sentriant AG appliance include inline, DHCP, and 802.1X deployments. For details
about the deployment options for the Sentriant AG appliance, refer to chapter 2 of the Sentriant AG
Software Installation Guide.
To connect the Ethernet ports, use Category 5 or better cable terminated in an RJ-45 connector.
Connect the port labeled eth0 to the corporate LAN (the internal network side).
Connect the port labeled eth1 to a switch or to a VPN or DHCP server (the Internet or endpoint side).
To connect the Console port to a PC or terminal server, use the provided DB-9-to-RJ-45 serial cable. For
more details, see
“Connecting to the Console Port” on page 17 .