Extreme Networks Sentriant AG200 - Manual (Page 17)

Sentriant AG200 Hardware Installation Guide 17
4 Startup and Configuration
The Sentriant AG200 appliance is shipped with the latest software installed. You must connect to the
server using the console port on the front panel to configure the Sentriant AG appliance for your
network with the correct IP address, default gateway, DNS server, and other settings.
This chapter includes the following sections:
● Connecting to the Console Port on page 17
● Using Console Menus on page 17
● Performing the Initial Setup on page 18
● Initial Configuration on page 23
● Enabling LAN Bypass on page 26
Connecting to the Console Port
Use the provided DB-9 to RJ-45 serial cable to connect the console port to a workstation running
software with console capability.
The console port has the following settings:
● 38400 baud
● 8 data bits
● 1 stop bit
● No parity
Log in the first time using the following default values:
● User name: root
● Password: sentriantag
When you log in the first time, the system will prompt you to change the default password. You must
change the password before you continue with the initial setup.
Using Console Menus
The initial setup process uses a series of console menus. To use the console menus:
1 Use the arrow keys to select a menu item to change.
2 When an item is highlighted, press [Tab] to select Edit and then press [Enter].
3 Type the information for the selected item and press [Enter].
You can select and edit other items from the menu.
4 When you have finished editing items, select OK.
A message is displayed asking if you want to save the changes.