Grass Valley Network Attached Storage System Serial ATA Network User Guide v.1.0.04 - Manual (Page 50)

Configuring Single Node Network Ports
Digital News Production 49
Configuring Single Node Network Ports
This window lets you view and modify a single node network port
configuration. The Single Node Network Port Configuration window appears
after you initially login to NewsShare NAS, or by choosing
Network |
Configure Single Node Network Ports . (If NewsShare NAS is not attached to
an existing network, do not change the values on this window.)
Step A. Configuring the Node
1. (Optional) Enable jumbo frames. Click on the check box to enable jumbo
frames (or to disable them when already enabled). Using standard frames,
the packets sent through the network are 1.5K. Using jumbo frames, the
packets sent through the network are 9K. Jumbo frames improve
performance.
NOTE: For information on using IP addresses in a network, refer to
“Basics of IP Addresses” on page 42.
2. (Optional) Enter a new value for the Public IP for port 0. Port 0 is the
external or data port. This is the address of the server nodes on the network.
3. (Optional) For port 0, enter the value for Netmask .
Step B. Saving the Configuration
To exit the window, click Next .