4 t u rn ing cy cles – HEIDENHAIN SW 54843x-03 User Manual
Page 199
Advertising
HEIDENHAIN MANUALplus 620
199
4.4 T
u
rn
ing cy
cles
Type of machining for technology database access: Finishing
Cycle run
1
Move paraxially from the starting point to the ICP contour starting
point
2
Finish defined contour area
3
Move to the tool change point according to the G14 setting
MFS
M at beginning: M function that is executed at the
beginning of the machining step.
MFE
M at end: M function that is executed at the end of the
machining step.
WP
Displays which workpiece spindle is used to process the
cycle (machine-dependent)
Main drive
Opposing spindle for rear-face machining
Advertising