Last cut, 6 thr ead and under c ut cy cles – HEIDENHAIN SW 54843x-03 User Manual
Page 276
Advertising
276
Cycle programming
4.6 Thr
ead and under
c
ut cy
cles
Last cut
After the cycle is finished, the MANUALplus presents the Last cut
option. In this way you can enter a tool compensation value and repeat
the last thread cut.
Initial situation: The thread cut cycle has been run, and the thread
depth is not correct.
Perform the tool compensation
Press the Last cut soft key
Activate Cycle Start
Check the thread
SEQUENCE OF THE "LAST CUT" FUNCTION
The tool compensation and the last cut can be repeated
as often as necessary until the thread is correct.
Advertising