HEIDENHAIN SW 54843x-03 - Manual (Page 447)

HEIDENHAIN MANUALplus 620 447
5.13 Lat
er
al surf
ace cont
ours in smar
t.T
u
rn
You can find the reference diameter XR with the "select reference
plane" function (siehe Seite 427).
ICP generates:
 The LATERAL_C section code with the reference diameter
parameter. In nested contours, ICP generates only one section
code.
 A G308 with the parameters contour name and milling depth or hole
depth (–1*BT).
 A G412 with the parameters of the pattern.
 The G function and the parameters of the figure/hole.
 A G309.
EP End angle (no entry: the pattern elements are equally divided
into 360°)
EPi Angle between two figures
H Element position
 0: Normal position—the figures are rotated about the circle
center (rotation)
 1: Original position—the position of the figures relative to
the coordinate system remains unchanged (translation)
Parameters of the selected figure/hole