HEIDENHAIN SW 54843x-03 - Manual (Page 24)

24
4.4 Turning cycles ..... 160
Tool position ..... 161
Cut longitudinal ..... 163
Cut transverse ..... 165
Roughing, longitudinal—expanded ..... 167
Roughing, transverse—expanded ..... 169
Finishing cut, longitudinal ..... 171
Finishing cut, transverse ..... 172
Finishing cut, longitudinal—expanded ..... 173
Finishing cut, transverse—expanded ..... 175
Cut, longitudinal plunge ..... 177
Cut, transverse plunge ..... 179
Cut, longitudinal plunging—expanded ..... 181
Cut, transverse plunging—expanded ..... 183
Cut, longitudinal finishing plunge ..... 185
Cut, transverse finishing plunge ..... 187
Cut, longitudinal finishing plunge—expanded ..... 189
Cut, transverse finishing plunge—expanded ..... 191
Cut, ICP contour-parallel, longitudinal ..... 193
Cut, ICP contour-parallel, transverse ..... 196
Cut, ICP contour-parallel, longitudinal finishing ..... 198
Cut, ICP contour-parallel, transverse finishing ..... 200
ICP cutting, longitudinal ..... 202
ICP cut transverse ..... 204
ICP longitudinal finishing cut ..... 206
ICP transverse finishing cut ..... 208
Examples of turning cycles ..... 210