HEIDENHAIN TNC 320 (340 551-02) - Manual (Page 306)

306 8 Programming: Cycles
8.7 Coor
dinat
e
T
ransf
or
mation Cy
cles
Configuring the datum table
If you do not wish to define a datum table for an active axis, press the
DEL key. Then the TNC clears the numerical value from the
corresponding input field?
To leave a datum table
Select a different type of file in file management and choose the
desired file.
Status displays
The additional status display shows the values of the active datum
shift (see “Coordinate transformations” on page36).
After you have changed a value in a datum table, you must
save the change with the ENT key. Otherwise the change
may not be included during program run.