HEIDENHAIN TNC 320 (340 55x-03) - Manual (Page 262)

262 8 Programming: Cycles
8.3 Cy
cles f
o
r Milling P
o
c
k
ets, St
uds and Slots
8.3 Cycles for Milling Pockets,
Studs and Slots
Overview
Cycle Soft key Page
4 POCKET MILLING (rectangular)
Roughing cycle without automatic pre-
positioning 263
212 POCKET FINISHING (rectangular)
Finishing cycle with automatic pre-
positioning, 2nd set-up clearance 265
213 POCKET FINISHING (rectangular)
Finishing cycle with automatic pre-
positioning, 2nd set-up clearance 267
5 CIRCULAR POCKET
Roughing cycle without automatic pre-
positioning 269
214 CIRCULAR POCKET FINISHING
Finishing cycle with automatic pre-
positioning, 2nd set-up clearance 271
215 CIRCULAR STUD FINISHING
Finishing cycle with automatic pre-
positioning, 2nd set-up clearance 273
210 SLOT RECIP. PLNG
Roughing/finishing cycle with automatic
pre-positioning, with reciprocating
plunge infeed 275
211 CIRCULAR SLOT
Roughing/finishing cycle with automatic
pre-positioning, with reciprocating
plunge infeed 278