7 optional block skip, Function, Inserting the “/” character – HEIDENHAIN TNC 320 (340 55x-03) User Manual
Page 465: Erasing the “/” character, 7 optional bloc k skip 11.7 optional block skip
HEIDENHAIN TNC 320
465
1
1
.7 Optional Bloc
k Skip
11.7 Optional Block Skip
Function
In a test run or program run, the TNC can skip over blocks that begin
with a slash “/”:
To run or test the program without the blocks
preceded by a slash, set the soft key to ON.
To run or test the program with the blocks preceded
by a slash, set the soft key to OFF.
Inserting the “/” character
In the Programming mode you select the block in which the character
is to be inserted.
Select the SHOW BLOCK soft key.
Erasing the “/” character
In the Programming mode you select the block in which the character
is to be deleted.
Select the SHOW BLOCK soft key.
This function does not work for TOOL DEF blocks.
After a power interruption the control returns to the most
recently selected setting.