Epson PRO 4800 User Manual
Page 133
6-133
Solving Problems
|
133
NOZZLES STILL
CLOGGED
—
Head cleaning did not
clear the nozzles.
Run the head cleaning utility again. If the
nozzles are still clogged, contact Epson.
OPTION I/F
ERROR
—
Wrong interface card
installed.
Turn off the printer and remove the card. See
the documentation that came with the card.
PAPER NOT CUT
Paper light
flashing
Roll paper was not cut
correctly.
The cutter may be
blunt or incorrectly
installed.
Open the top cover and remove the uncut
paper. Reload paper if necessary.
Reinstall or replace the cutter blade if
necessary, as described on page 118.
PAPER NOT
STRAIGHT
Paper light
flashing
Paper slipped and fed
into the printer at an
angle.
Reload paper, making sure the edges are
straight.
PAPER OUT
Paper light
on
No paper is loaded.
Paper ran out.
Load paper.
Remove any printouts or paper remaining in the
printer and load more paper.
If the message appears during a print job, reset
the printer by pressing the Pause button for
3 seconds. Then load paper and resend the job.
REAR COVER
OPEN
—
The rear cover has
been removed.
Replace the rear cover.
RELEASE LEVER
REMOVE PAPER
JAM
Paper light
flashing
Paper has jammed in
the printer.
Remove the jammed paper. See page 142 for
more information.
RELOAD PAPER
Paper light
on
Printer cannot detect
paper.
PAPER NOT CUT error
was cleared.
If you are using cut sheets, make sure the
paper is flat. Move the paper lever.
Reload paper.
RELOAD PAPER
INSERT DEEPLY
Paper light
on
Manually loaded sheet
is not inserted far
enough.
Insert the sheet further into the printer. See
page 44 for instructions.
REMOVE PAPER
Paper light
on
Paper is too thick for
head cleaning.
Printer could not feed
the printed page.
Pull the paper lever out to remove the paper.
Head cleaning automatically starts. After
cleaning, reload paper.
Remove the print.
REPLACE
CNVRSION CRTG
—
The conversion
cartridge needs to be
replaced.
Replace the conversion cartridge with a new
one. Or, complete the replacement of the black
ink by pressing the
Pause button.
Message
Light
Explanation
Response
sp4800Guide.book Page 133 Tuesday, March 7, 2006 3:49 PM