HEIDENHAIN TNC 620 (81760x-01) Cycle programming - Manual (Page 394)

Touch Probe Cycles: Automatic Workpiece Inspection
16.7 MEASURE RECTANGLE INSIDE (Cycle 423, DIN/ISO: G423, software
option 17)
16
394
TNC 620 | User's Manual Cycle Programming | 3/2014
Measuring log Q281: Define whether the TNC
should create a measuring log:
0 : Do not create a measuring log
1
: Create a measuring log: The TNC saves the
log
file TCHPR423.TXT as standard in the directory
TNC:\.
2 : Interrupt program run and output measuring log
to the TNC screen. Resume program run with NC
Start.
PGM stop if tolerance error Q309: Definition of
whether in the event of a violation of tolerance
limits the TNC is to interrupt program run and output
an error message:
0 : Do not interrupt program run, do not output an
error message
1 : Interrupt program run and output an error
message
Tool for monitoring Q330: Definition of whether
the TNC is to monitor the tool (see "Tool
monitoring", page 378). Input range 0 to 32767.9,
alternatively tool name with maximum of 16
characters
0 : Monitoring inactive
> 0 : Tool number in the tool table TOOL.T