Enterasys Networks 1G58x-09 User Manual
Page 526
Logging and Network Management Command Set
Managing Switch Network Addresses
11-56
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Defaults
•
If not specified, waittime will be set to 5 seconds.
•
If not specified, first-ttl will be set to 1 second.
•
If not specified, max-ttl will be set to 30 seconds.
•
If not specified, port will be set to 33434.
•
If not specified, nqueries will be set to 3.
•
If -r is not specified, normal host routing tables will be used.
•
If -d is not specified, the debug socket option will not be used.
•
If not specified, tos will be set to 0.
•
If -F is not specified, the ‘don’t fragment’ bit will not be applied.
•
If gateway is not specified, none will be applied.
•
If -I is not specified, UDP datagrams will be used.
•
If -v is not specified, summary output will be displayed.
•
If -x is not specified, checksums will be calculated.
Command Type
Switch command.
Command Mode
Read-Only.
-x
(Optional) Prevents traceroute from calculating
checksums.
host
Specifies the host to which the route of an IP packet will
be traced.
packetlen
(Optional) Specifies the length of the probe packet.