Enterasys Networks 1G58x-09 - Manual (Page 732)

Security Configuration Command Set
Configuring MAC Locking
14-50 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to disable MAC locking on Fast Ethernet front panel port 3:
14.3.4.5 set maclock
Use this command to create a static MAC address and enable or disable MAC locking for the
specific MAC address and port. When created and enabled, this allows only the end station
designated by the MAC address to participate in frame relay.
set maclock mac_address port-string {create | enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>set maclock disable fe.0.3
NOTE: Configuring one or more ports for MAC locking requires globally enabling it on
the device first using the set maclock enable command as described in
Section 14.3.4.3 .
mac_address Specifies the MAC address for which MAC locking will
be created, enabled or disabled.
port-string Specifies the port on which to create, enable or disable
MAC locking. For a detailed description of possible
port-string values, refer to
Section 4.1.2 .
create Establishes a MAC locking association between the
specified MAC address and port. Create automatically
enables MAC locking between the specified MAC
address and port.
enable | disable Enables or disables MAC locking between the specified
MAC address and port.