Lanner LEC-3100 - Manual (Page 8)

6
Introduction
Chapter 2
Embedded and Industrial Computing
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server The front panel Power On/Standby button
does not completely shut off system power
Portions of the power supply and some internal
circuitry remain active until AC power is removed
Unpower the LEC-3100 and remove the power cord 1
Unscrew the 4 threaded screws from the side and 2
3 from the back of the top cover on the LEC-3100
System
Slide the cover backwards and open the cover 3
upwards
Installing the System Memory
The motherboard supports DDR2 memory that features
data transfer rates of 533 MHz to meet the higher
bandwidth requirements of the latest operating system
and Internet applications It comes with one Double Data
Rate(DDR2) Small Outline Dual Inline Memory Modules
(SO-DIMM) socket
Align the cutout of the SO-DIMM with the notch of the 1
memory slot
Install the SO-DIMM 2
Cutout
Notch
Note:
The SO-DIMM installed must meet the speed 1
requirement (DDR2 533) Do not install DIMMs
supporting different speeds
The motherboards can support up to 2 GB 2
memory capacity in maximum
Installing the Hard Disk
The system can accommodate one Serial-ATA disks Follow
these steps to install a hard disk into the LEC-3100:
Unsrew the 4 screws on the hard disk tray to take out 1
the hard disk tray from the system
Place hard disk on the hard disk tray and align the holes
2
of the hard disk with the mounting holes on the tray
Secure the hard disk with 4 mounting screws on the
3
hard disk tray
Connect the Serial-ATA power and drive cables to the
4
hard disk’s power and drive connectors respectively
Plug the Serial-ATA cables to the Serial-ATA Connectors
5
on the main board
Put the hard disk tray with the installed hard disk
6
back to the system and secure it with the mounting
screws
1
2
1