LeMond RevMaster Classic - Manual (Page 11)

Page 5
7. The handlebar post is the post that has a smooth finish, and no
groove on top. Insert the handlebar post into the handlebar tube.
Loosely thread a handle without a washer into the main frame.
Raise the handlebar post to the desired height and tighten the
handle to secure the handlebar post.
Note: The black handles are spring loaded. Once tightened,
ensure that the handle does not stick out to the side from the
main frame. Pull down on the handle and rotate it such that it
does not stick out. Release the handle and lock it into place.
8. Position the handlebar over the handlebar post. Loosely thread a
handle with a washer through the handlebar post into the handle-
bar. Slide the handlebar to the desired
position and tighten the handle.
9. The 4-mm screw that mounts the
water bottle cage is located in the
water bottle clamp on the handlebar
assembly. Remove the screw from
the clamp and position the water
bottle cage over the clamp. Reinstall the screw and tighten the
water bottle cage to the clamp.
10. The seat post is the post that has a rough finish, and a groove on
top. Insert the seat post into the seat post tube. Loosely thread a
handle without a washer into the main frame. Raise the seat post
to the desired height and tighten the handle to secure the seat
post.
INSTALLATION INSTRUCTIONS
Handlebar Post
Seat Post