LeMond RevMaster Classic - Manual (Page 12)

Page 6
11. Position the seat with seat slider over
the seat post. Loosely thread a
handle with a washer through the seat
post into the seat slider. Slide the seat
to the desired position and tighten the
handle.
12. The pedals are marked as if you are seated on the bike, "R" for
right, and "L" for left. Carefully thread the right pedal into the
crank arm with your fingers - do not cross thread the pedal in the
crank arm! Use the wrench tool to tighten the pedal. Repeat this
step for the left pedal.
Note: The left pedal is reverse-threaded.
Seat Post
Seat Post
Adjustment
Handle
Seat
Seat Adjustment
Handle
Handlebar
Handlebar Post
Adjustment Handle
Front Cross Arm Back Cross Arm
INSTALLATION INSTRUCTIONS