LeMond RevMaster Classic - Manual (Page 21)

Page 15
PARTS REMOVAL AND REPLACEMENT
ADJUSTMENT HANDLES
Handlebar/Seat post adjustment handle
1. Support the post with one hand and rotate the adjustment handle
counterclockwise with your other hand until the handle is un-
threaded from the frame.
2. Lower the post so that it rests on the frame.
3. Apply a thin layer of grease on the threads from half way to the end
of the threads. Thread the new handle halfway into the frame.
Position the post in the desired location. Rotate the adjustment handle
clockwise to secure the post.
4. Ensure that the handle does not stick out to the right or left. Each
handle is spring loaded so that you can properly align the frame and
the handle. Simply pull out on the handle and rotate it for correct
alignment.
Handlebar/Seat adjustment handle
1. Rotate the adjustment handle counterclockwise to loosen the
seat and/or handlebar.
2. Slide the seat back or the handlebar forward on the frame.
3. Continue rotating the handle counterclockwise until it is un-threaded
from the seat and/or handlebar.
4. Apply a thin layer of grease on the threads from half way to the end
of the threads. Thread the new handle halfway into the seat and/or
handlebar. Position the seat and/or handlebar in the desired location.
Rotate the adjustment handle clockwise to secure the seat and/or
handlebar.
Note: The seat slider has two holes from
which to position the seat.
5. Ensure that the handle does not
stick out to the right or left. Each
handle is spring loaded so that you can
properly align the frame and the handle.
Simply pull out on the handle and rotate it for correct
alignment.