Emerson Radio AV101 - Manual (Page 42)

41
Adjusting the Left/Right Balance
If your normal listening position is closer to one side
of your room rather than in the exact center, you can
compensate by adjusting the Balance control.
Press the CH LEVEL button on the remote control. The
balance setting will appear on the front panel display as
follows:
The above display indicates an equal balance between
the left and right speakers. To shift the balance to the
right, press the “+” (R) button. To shift the balance to the
left, press the “-” (L) button. Note you must make the
adjustments while the balance setting appears on the
front panel display.
Center Level, Rear Level, and
Subwoofer Level Adjustments
If the sound from the center speaker or rear speakers,
or the subwoofer is too strong or too weak while you are
watching a movie you can adjust those levels with the
CH LEVEL and +/- buttons on the remote control. Press
the CH LEVEL button repeatedly until the front panel
display shows the speaker that you wish to adjust:
CENTER, R-REAR, L-REAR, SUBB. Then press the “+”
or “-” buttons to increase or decrease the level of that
speaker. The adjustment range is +/- 10dB in 1 dB steps.
Other Sound Effects
When listening to music press the DSP Mode button
on the remote control repeatedly to cycle through the
following special Surround Sound options: PRO LOGIC
g3 STEREO gCONCERT gLIVING gHALL gBATH
ROOM gCAVE gARENA gCHURCH gSTEREO g
PRO LOGIC. Select the option that provides the most
desirable effects for the particular type of music that you
are playing.
Listening to the Radio
(Continued)
To listen to non-preset radio stations
Use manual or automatic tuning in step 2.
For manual tuning, press TUNING (5or6) repeatedly.
For automatic tuning, press and hold TUNING (5or6)
until the frequency indicator starts to change
automatically, then release the button.
If an FM program is noisy
Press MONO/STEREO button on the remote control so
that “MONO” appears on the front panel display. There will
be no stereo effect, but the reception will improve. Press
the button again to restore the stereo effect.
To improve reception
Reorient the supplied antennas.
Bass and Treble Adjustments
These adjustments can be made while a movie is
playing or while the disc is stopped.
The default setting for the Bass and Treble level of the 5
satellite speakers is 0dB. To increase or decrease the
Bass or Treble levels press the Bass or Treble buttons
on the remote control. The front panel display will show
Bass or Treble and “0 dB”. While the Bass or Treble
level appears on the front panel display press the CH.
LEVEL “+” or “-” buttons to adjust the levels up or down
as desired.