Electrolux EMS26405 - Manual (Page 42)

electrolux installation 42
Installation
Installing the appliance
1. Remove all packaging and check
carefully for any signs of damage.
2. If fitting the microwave oven above
a conventional oven (position A)
then use the mylar sheet provided.
a. Cut the Mylar sheet to fit the
internal width of the unit.
b. Peel back the protective cover
on the tape and fix to the rear of
the shelf so that it covers the
service gap. (See diagram).
3. Fit the appliance into the kitchen
cupboard slowly, and without
force, until the front frame of the
oven seals against the front
opening of the cupboard.
4. Ensure the appliance is stable and
not leaning. Ensure that a 5 mm
gap is kept between the cupboard
door above and the top of the
frame (see diagram).
Mylar sheet
Conve
ntional
oven
Serv
ice g
ap
Interna
l width
5 mm
5. Fix the oven in position with the
screws provided.
The fixing points are located on the
top and bottom corners of the oven
(see diagram, item 10, page 9).
6. It is important to ensure that the
installation of this product
conforms to the instructions in this
operation manual and the
conventional oven manufacturer’s
installation instructions.
The microwave can be fitted in
position A or B:
D
Chimney Chimney
Conventional
oven
Position A Position B
Position Niche Size Chimney Gap
W D H (min) Between
Cupboard
& Ceiling
A 560x550x450 50 50
B 560x500x450 40 50
Measurements in (mm)
Note: Ensure the bottom of the
oven is 85 cm or more above
the floor.
EX-72F-UK English:NEW Electrolux_MG BASE_English 24/4/07 11:39 Page 42