Extron Electronics RAC 104 - Manual (Page 16)

RAC 104 • Installation and Operation
Installation and Operation, cont’d
Furniture mounting
Furniture mount the RAC 104 using the optional MBU 123
mounting kit (Extron part #70-212-01) as follows:
1 . Remove rubber feet if they were previously installed on
the bottom of the RAC 104.
2 . Attach the furniture mounting brackets to the RAC 104
with the machine screws provided.
3 . Hold the RAC 104 with the attached brackets against the
underside of the table or other furniture. Mark the
location of the screw holes of the bracket on the mounting
surface.
4 . Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
5 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" of the screw protrudes.
6 . Align the mounting screws with the slots in the brackets
and place the RAC 104 against the surface, with the screws
through the bracket slots. See the illustration below.
7. Slide the RAC 104 slightly forward or back, then tighten all
four screws to secure the unit in place.
VO LU ME & T ON E C ON TR OL LE R
1
2
3
4
Bas s Tre ble
Vol.
AD JU ST ME NT S
AU DIO CO NT RO LS
A
B
Mounting the RAC 104 under furniture
2-4