Enterasys Networks A2H124-24FX - Manual (Page 64)

Using LANVIEW
4-2 Troubleshooting
Using LANVIEW
The A2H124‐24FX supports the Enterasys Networks built‐in LANVIEW LED visual
diagnostic and status monitoring system. The LANVIEW LEDs on the A2H124‐24FX are
located as shown in
Figure 4‐1 . These LEDs allow you to quickly observe network status
for diagnosing switch and network problems.
Figure 4-1 LANVIEW LEDs of A2H124-24FX
1 Recessed Password Reset Button 5 100BASE-FX Ports Link/Activity
2 Redundant Power Supply Active 6 1000 Mbps Stacking Port Link/Activity
3 Unit selected as Stack Manager 7 Mini-GBIC Link/Activity
4 CPU and Power Indicator
Note: The terms flashing, blinking, and solid used in Table 4-1 indicate the following:
Flashing: LED is flashing randomly.
Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid: LED is on steady and not pulsing.
Console CPU
RPS
MGR 1 3 5 7 9 11 13 15 17 19 21 23
2 4 6 8 10 12 14 16 18 20 22 24
25
26
27
28
25/Up 26/Down
Stack
27 28
2 8 10 12 4 6
1 7 9 11 3 5 13 19 21 23 15 17
14 20 22 24 16 18
Д Е
Б
В
Г
А
CPU
RPS
MGR
Ж