Enterasys Networks V2H124-24P - Manual (Page 22)

Introduction
1-2
1
This switch includes two Gigabit combination ports with RJ-45 connectors and
associated SFP slots. The optional SFP stacking transceiver enables up to eight
units to be connected together through a 1 Gbps stack backplane. The switch stack
can be managed from a master unit using a single IP address.
Power-over-Ethernet Capability
The switch’s 24 10/100 Mbps ports support the IEEE 802.3af Power-over-Ethernet
(PoE) standard that enables DC power to be supplied to attached devices using
wires in the connecting Ethernet cable. Any 802.3af compliant device attached to a
port can directly draw power from the switch over the Ethernet cable without
requiring its own separate power source. This capability gives network
administrators centralized power control for devices such as IP phones and wireless
access points, which translates into greater network availability.
For each attached 802.3af-compliant device, the switch automatically senses the
load and dynamically supplies the required power. The switch delivers power to a
device using the two wire pairs in UTP or STP cable that are not used for 10BASE-T/
100BASE-TX connections. Each port can provide up to 15.4 W of power at the
standard -48 DC voltage. Independent overload and short-circuit protection for each
port allows the switch to automatically shut down a port’s power when limits are
exceeded.
Network devices such as IP phones, wireless access points, and network cameras,
typically consume less than 10 W of power, so they are ideal for
Power-over-Ethernet applications.
Network Management Options
With a comprehensive array of LEDs, this switch provides “at a glance” monitoring of
network and port status. The switch can be managed over the network with a web
browser or Telnet application, or via a direct connection to the console port. The
switch includes a built-in network management agent that allows it to be managed
in-band using SNMP or RMON (Groups 1, 2, 3, 9) protocols. It also has an RS-232
serial port (DB-9 connector) on the front panel for out-of-band management. A PC
may be connected to this port for configuration and monitoring out-of-band via a
null-modem serial cable. (See "Connecting to the Console Port" on page 3-8 for
wiring options.)
For a detailed description of the advanced features, refer to the Management Guide.