Enterasys Networks V2H124-24P - Manual (Page 26)

Introduction
1-6
1
Stack Master Button
The unit also includes a Stack Master button that is shown in the following diagram.
Figure 1-4. Stack Master Button
The Stack Master button enables one switch in the stack to be selected as the
master.
Mode PoE/Link Button
The Mode PoE/Link button is located on the front panel.
Figure 1-5. Mode Selection
The Mode PoE/Link button is used to toggle between the two port status LED
display modes (see "Port Status LEDs" on page 1-4). Pressing this button changes
from one display mode to the other. The default display mode is Link/Act mode.
Stack Master Button
Link/Act
PoE
25
26
PWR
Diag
Stacking
Mode
PoE/Link
Mode Select Button