Enterasys Networks V2H124-24P - Manual (Page 40)

Installing the Switch
3-6
3
Stacking Switches
The switch supports stacking up to eight units through an optional SFP stacking
transceiver. The stacking transceiver must be installed in the port 25 slot. Each
stacking transceiver has two connectors, Tx and Rx, for attaching stacking cables.
Figure 3-7 shows how stacking cables are connected between switches in a stack.
Note: The stacking transceiver must only be installed in the port 25 SFP slot.
Installing a Stacking Transceiver
The stacking transceiver must be installed in the port 25 slot. It should be inserted
before any of the systems in the stack are powered on.
Figure 3-6. Installing a Stacking Transceiver
Slide the SFP transceiver into the SFP transceiver slot until it clicks into place. To
remove, pull on the tab at the bottom of the front of the transceiver.
2
23
24
25
23
2
23
24
25
23
Remove Transceiver
by Pulling Tab
Slide Transceiver into
SFP Transceiver Slot
Tx
Rx