EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge User Manual
Page 11
Version 1.02
18
shown below.
Step 2 Press <Esc> keystroke to reboot the Wireless client bridge. Press
<x> key during the boot process, and it will display prompt
character NetARM> as the figure shown in the next page.
Step 3 Press “h” keystroke, it will display related commands as the figure
shown below.
Version 1.02
19
Step 4 Select “F -- upgrade Flash memory” and it will display upgrade
items for selection as the figure shown below.
Step 5 Select “3: SOHO” and select “4: WEBIMG” to update the firmware
files one by one.
Step 6 While the window starts to display “C” character continuously, click
Transfer and select the new firmware files <soho.bin> file, press
“OK” to start to transfer file to Wireless client bridge.
Step 7 Select “4” to upgrade WEBIMG file. The procedures are the same
with upgrading SOHO file (go back to step 5), but should select
<pfs.img> file correctly for WEBIMG file upgrade.
Step 8 After the upgrade completes, remember to press “R” keystroke to
reboot the system.
Note: The default transfer protocol is using “Xmodem”, so please make
sure you select correct protocol to download/upload files when you
try to upgrade the Wireless client bridge’s firmware files.