EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge - Manual (Page 6)

Version 1.02 8
NOTE: This connection is required for setting up initial configuration
information. After configuration is completed, the RS-232 null
modem console cable shall be removed, and run a cross-over
Ethernet cable from Data Input Port to PC, or a straight Ethernet
cable to LAN connection, e.g. Hub.
Step 5
Attach one straight Ethernet cable to the Power & Data Output
Port on the Inline Power Injector(refer to page 5 ).
Step 6
Plug the other end of the straight Ethernet cable to the Ethernet
Port (refer to
page 5 ) on the Wireless client bridge.
When the Wireless client bridge receives power over the Ethernet cable,
the Wireless client bridge will start its boot sequence and the Active LED
on the Inline Power Injector will light up.
You can configure the Wireless client bridge via HTML browser, such as
Microsoft Internet Explorer or Netscape Navigator from a remote host or
PC.
Version 1.02 9
2.4 Basic Configuration
2.4.1 What you need to know
The Wireless client bridge can be configured into two operation roles,
including Wireless Client Bridge and Wireless Client Router.
The Wireless client bridge is shipped with default configuration to function
as a client bridge between an Ethernet and Wireless network by attaching
Wireless client bridge to the wired LAN simply. If user would configure
Wireless client bridge, please refer to the following procedures.
2.4.2 Basic Configuration Steps
This section describes a five-step configuration procedure to setup
Wireless client bridge workable upon your topology requirement.
Step 1 Select an operation mode for Wireless client bridge on the web
page “/General Config/System/”, and click FINISH to refresh this
page.
Step 2 Modify the factory-default parameters on the web page “/General
Config/System/”, and click FINISH to save the changes.
Step 3 Modify the factory-default parameters on the web page “/General
Config/Wireless/”, and click FINISH to save the changes.
Step 4 (Optional) Modify other parameters on the web page “/General
Config/”, and click FINISH to save the changes.
Step 5 Move to page “/Utility/Administration/”, select the Save
then Restart and then click FINISH to take effect on the previous
configuration changes.