EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge - Manual (Page 12)

Version 1.02 20
2.4.8 Back-up the Wireless client bridge’s Configuration
Files
After configuring Wireless client bridge, user can back-up the configuration
files. User can upload the latest back-up files and recover the Wireless
client bridge configuration to the settings specified in the back-up files.
„
Downloading Configuration Files
Just being the same with firmware upgrade procedures. After the prompt
character NetARM> is displayed, select “S – Save image to file”, and then
select “6: CONFIG” to back-up the Wireless client bridge configuration as
the figure shown below. The back-up file will be saved as <CONFIG.IMG>
file.
„
Uploading Configuration Files
To upload an configuration file to Wireless client bridge, user should select
“F -- upgrade Flash memory” and then select “6: CONFIG”. While the
window starts to display “C” character continuously, click Transfer and
select the preferred <CONFIG.IMG>, then press OK to start transferring file
to Wireless client bridge.
Version 1.02 21
Note: Remember to press “R” to reboot the system after you upload the
configuration file to the Wireless client bridge