Emotiva DMC-1 - Manual (Page 14)

Page 14 Page 15
DMC-1 Front Panel Features
Power Button
This turns the DMC-1 on or off. It is a non-
latching momentary button. If you press
Z II first, it can turn on Zone 2 (even if the
Main Zone is off).
IMPORTANT – Please note the DMC-1
requires initialization after the power cord
is plugged into the AC receptacle. Push and
hold the power button for approx. 5 seconds.
The unit will power up after this small delay.
The second push of the power button will
turn the unit off and after this the unit will
turn on and off in a normal fashion.
Rotate this manual control clockwise to
increase the volume. The dB level will
appear in the front panel display. When
turning on a new source, make sure the
level is low, such as -80 dB and increase
it slowly. The dB display becomes less
negative as the volume increases.The
DMC-1 volume control is velocity sensitive.
If turned slowly, the volume will change
in small increments. If rotated quickly,
level change will be made in larger
increments.
Note: When the DMC-1 is turned on, it has a
deliberately slow and smooth volume ramp
from silence, up to the level that was set when
the unit was last turned off. It can also be
programmed to come up to a preset volume
you have selected, rather than the previous
volume.The knob does not turn when volume
is operated from the DMC-1 remote.
1
4
2 4
5
3
6 7 8
9
10
2 IR Receiver Window
This window should be clean and free from
obstruction for the remote control to work
correctly.
3
Processor Display
This soothing blue display shows
which input is selected, the tuner
frequency, volume level, and other useful
information.
1