Emotiva DMC-1 - Manual (Page 92)

Page 92 Page 93
Line Level Inputs
Sensitivity
(for 0.5 V output): 125mV
Phono: 1.6mV
Frequency Response:
+/- 0.5 dB: 20 Hz-20 kHz
Signal to Noise Ratio
(relative to 2V out):
Analog 97 dB
Digital 105 dB
Distortion (THD): <0.03%
Separation (@1kHz): 70dB
Tone Control
Bass: +/- 10dB
Treble: +/- 10dB
Audio Output Section
Frequency Response
Main Channels (Large):
20Hz-20kHz
Subwoofer (LFE): 20Hz-160Hz
(Note - The subwoofer crossover is set at 160Hz. The
subwoofer plays the bass from the other channels
using the LFE Bass Management function in the
signal processing formats)
Delay Adjustment
Center: 0-25 ms
Rear: 0-25 ms
Video Section
Video Inputs/Outputs:
1V p-p, 75 Ohm
Bandwidth
Component Video:
100MHz, -1.5dB
S-Video: 6MHz, -2dB
Composite Video: 18MHz, -1.5dB
(Video transcoder / up converter circuitry is
completely automatic)
FM Tuner Section
FM Range: 87.5-108MHz
0.2MHz Steps
Usable FM Sensitivity (Mono)
1.6uV@75 Ohms
@75kHz 15.2 dBf (DEV 30dB)
50dB Quieting Sensitivity (Stereo)
31.6 uV @75 Ohms
41.2 dBf
Audio Output Bandwidth (+.5, -3dB)
30Hz-15kHz
AM Tuner Section
AM Range:
530-1710kHz
10kHz steps
Usable AM Sensitivity (S/N 30% modulated)
@20dB S/N 16uV / (600uV/m)
@1mV input 48dB
Trigger Outputs
12 Volt MAIN and ZONE2 Trigger
Current load <500mA total
MAIN Zone Trigger Relay Contact Rating
24VDC @ 2a Max
XLR Outputs
Pin #1 = Ground
Pin #2 = Positive
Pin #3 = Negative
Infrared Outputs (Optically Isolated)
1/8” Jacks @ 12V level
Power Requirements
120VAC, 60Hz, 40W
Dimensions
17”Wx5.75”Hx15.5”D
Net Weight
22 lbs
Technical Specifications
Pin #1 Pin #2
Pin #3