Emulex DCP_link - Manual (Page 118)

X.25 Configuration 7-25
NOTE: Most installations can function properly with the
factory default parameters. For non-standard
applications, refer to the Novell NetWare MPR
3.0 Advanced Configuration and Management
Guide.
Binding Network Protocols to a WAN Interface
After adding and configuring the desired protocols outlined above, complete
the following steps to bind a given protocol, such as IPX, to the WAN
interface and to select a permanent WAN Call Destination (if applicable):
1) From the Internetworking Configuration menu, select Bindings then
press <Enter>.
Figure 7-11 Internetworking Configuration
2) A new window displays a list of the Configured Protocol To Network
Interface Bindings.
Figure 7-12 Configured Protocol to Bindings
3) Press <Ins> to display a list of the configured protocols.