Emulex DCP_link - Manual (Page 76)

Software Configuration 5-7
Figure 5-4
6) Review the default values in the Board Configuration menu,
and m
NOTE: iew
akes changes as needed.
Refer to Chapter 2 of this guide to rev
the default configuration information used
while installing the Emulex DCPx86i/e
adapter. For non-standard installations,
please refer to the Emulex DCP_link
Advanced Configuration Manual.
7) Onc gs, press
<Esc> and se ration.
Note: Any conflicts with the chosen hardware
e you have finished reviewing the default settin
lect Yes to save changes to the board configu
parameters will cause error messages to be
displayed. Please contact Emulex technical
support if conflicts cannot be resolved.
8) The Configured Boards window is redisplayed with the latest
configuration changes. Note that the board status is Enabled.