Programming the overload warning value – Silvercrest Z30412-DK User Manual
Page 190
Advertising
192 GB/MT
the time at which the maximum power
consumption was measured, along
with the power factor in cos phi.
Note: The maximum power consump-
tion is stored until a higher value is
measured. Only then is the older val-
ue overwritten in the meter‘s memory.
Press and hold down the FUNCTION
button
2
for approx. 3 seconds to
erase the stored values.
Programming the
overload warning value
Note: In addition to a maximum value
for the power consumption (W), you can
program a maximum value for the current
(A). Here again, the energy cost meter
carries out further measurements if the
maximum value is exceeded.
66149_silv_Energiekosten-Messgerät_Content_ES-IT-PT-GB.indd 192 25.05.11 12:21
Advertising