Silvercrest SCM 1500 A1 - Manual (Page 10)

8
Warning!
– Never add toppings to the crêpe
while it is still on the baking plate 1.
Always wait until it has been removed
from the baking plate 1, otherwise
your topping may leak into the appli-
ance.
– Never cut the crêpe while it is still on
the baking plate, as this may damage
the non-stick coating.
– Never use sharp or metallic objects to
turn the crêpe or lift it off the baking
plate, as this could damage the non-
stick coating.
13.Remove the power supply plug from the
mains socket after use. This is the only
way to ensure that the appliance is
completely de-energized.
7. Cleaning and storage
Warning! To avoid the danger of
an electric shock or burning:
– Always remove the plug from the
mains socket before starting to
clean the appliance.
– Never immerse the appliance in
water, and protect it from
splashes and water droplets.
– Before cleaning, allow the
appliance to cool down to avoid
the risk of burns.
Caution! Never use abrasive, corrosive or
caustic cleaning materials. These could
damage the appliance as well as the non-
stick coating.
Note: Do not leave it too long to clean the
appliance, otherwise residues of batter may
dry on and be difficult to remove.
1. Wipe the bottom section 2 with a soft,
damp cloth. You can also use a little mild
detergent, but if doing so, take care to wipe
the appliance again afterwards with clean
water to avoid any aftertaste affecting the
flavour of the crêpes.
2. Wipe dry with a dry cloth.
3. The baking plate 1, batter spreader 6
and crêpe flipper 7 can be cleaned in
the sink using mild detergent solution.
Note: The baking plate 1 is
dishwasher-friendly.
4. Do not use the appliance again until all
components have completely dried.
5. To store the appliance, wind up the
mains cable on the reel on the bottom.
Insert the plug in the special holes in the
centre of the bottom section.
6. Store the machine in a clean, dry place.
RP90844 Crepes-Maker LB4 Seite 8 Montag, 5. August 2013 10:52 10