Installation, Uninstalling the device – Silvercrest SAB 160 A1 User Manual
Page 15
13
Installation
SAB 160 A1
GB
If necessary secure your device against theft with additional measures.
♦
Attach the securing screw with the anchoring plate
50
and the securing
material to the engine fi rewall of the vehicle.
Carefully push the device into the mounting duct until it locks into place.
♦
After all connections have been made activate the
♦
RESET button with a ball
point pen or other pointed object.
Attach the face plate as described under “Installing the face plate”.
♦
IMPORTANT
Possible damage to the cable!
Observe the position of the cable when sliding the device into the duct so
►
as to avoid damaging it.
Finally put on the bezel frame.
♦
Uninstalling the device
To remove the installed device proceed as follows:
Remove the bezel frame
♦
47
.
Insert the right and left keys
♦
49
into their respective slots on the sides of the
device. (The tabs are now bent back.)
Pull the device out.
♦