Silvercrest SAB 160 A1 - Manual (Page 37)

35
Troubleshooting
SAB 160 A1
GB
Defect Possible cause Solution
The CD jumps
The mounting angle exceeds
30°.
Correct the mounting angle.
The CD is very dirty or
defective.
Clean the CD or insert a diff erent CD.
Failure with
burnt CDs Check the burnt CD in another
playback device.
The radio and/
or the automatic
station saving is
not functioning
The antenna cable is not
connected correctly. Check the antenna cable for correct
connection.
The station signals are too
weak.
Set the station manually.
Station memory
is not functioning
The connection 4 in the ISO
block A (Permanent positive)
is not connected correctly.
Check the cable connections. For this
consult the chapter "Connections".
The device's USB
port does not
function
The USB port is intended for
devices that function accord-
ing to the USB standard. Not
all market available devices
conform to this standard. It
is possible that a device is
connected that does not func-
tion according to the USB
standard.
Connect a device that functions accord-
ing to the USB standard. Make sure
that the data carrier is formatted for the
FAT32 fi le system.
The card reading
device does not
read the cards The card is possibly defec-
tive, dirty or not properly
inserted.
Check the card. Slide it in with the
inscribed side facing to the right. Make
sure that the data carrier has been
formatted to the FAT32 fi le system.
The Bluetooth
connection does
not function
The mobile phone does not
support Bluetooth transmis-
sions.
Reconnect the mobile phone and the
device. For this also read, without fail,
your mobile phone's instructions.
The mobile phone is not
coupled with the device.
NOTICE
If you cannot solve the problem with the aforementioned methods, please ►
contact Customer Service.