Silvercrest SAB 160 A1 - Manual (Page 19)

17
Handling and operation
SAB 160 A1
GB
TAVOL - Volume for traffi c radio
Turn the multi controller to set the volume level, with which traffi c reports are ♦
to be played back.
EON - Information from other stations
When the EON function is switched on the radio switches to traffi c radio or PTY
groups if the TA or PTY function has been activated.
Turn the multi controller in order to switch the EON function on (EON ON) ♦
or off (EON OFF).
DSP - Equalizer (Digital Sound Processing)
Turn the multi controller to select one of the settings ♦ CLASSICS, ROCK M,
POP M, FLAT or DSP NONE. In the setting DSP NONE no DSP is
switched on. The DSP equalizer setting is shown to the right in the display.
TA - Traffi c Announcement (traffi c radio)
Turn the multi controller to perform the following settings: ♦
TA SEEK: As soon as the reception signal for traffi c announcements becomes
weaker or you leave the reception area the search function starts and will look
for the strongest TA station.
TA ALARM: As soon as the reception signal for traffi c announcements becomes
weaker or you leave the reception area an alarm tone sounds.
PI - Program Identifi cation (Sound with the station search)
The programme identifi cation code (PI) is a built-in transmission identifi cation
code, which is used for, among other things, the search of alternative frequencies.
It consists of a 16 bit rate which allows for a positive identifi cation of the station.
Turn the multi controller to perform the following settings: ♦
PI SOUND: Station search with sound.
PI MUTE: Station search without sound.
RETUNE (Search times of stations with PI recognition)
Turn the multi controller to perform the following settings: ♦
RETUNE L: The search process for a station with the correct PI recognition runs
for 90 seconds.
RETUNE S: The search process for a station with the correct PI recognition runs
for 30 seconds.