Silvercrest SEAD 1800 B1 - Manual (Page 70)

68
• Only place the appliance on a level,
dry, non-slip surface so that the
appliance can neither fall over nor slide
off.
• Do not place the appliance immediately
underneath a suspended cupboard, as
steam escapes upwards and might
damage the furniture.
• Do not place the appliance on a hot
cooking ring.
• The appliance and accessories may not
be put in a microwave oven.
5. Unpacking and setting up
Note: As the appliance is supplied with a
thin film of grease, there might be a small
amount of smoke and odour the first time it is
used. This is not harmful and will stop after a
short time. Please ensure adequate
ventilation during this process.
1. Remove the individual parts from the
packaging.
2. Check that the individual parts are
complete (see “1.2 Scope of supply” on
page 64) and are undamaged.
3. Clean the appliance thoroughly before
using it for the first time (see
“9. Cleaning and storing” on page 74).
4. Unwind the mains cable 8 from the
cable store over its entire length.
5. Place the appliance on a level, dry, non-
slip surface so that the appliance can
neither fall over nor slide off.
6. Insert the power supply plug in a
suitable earthed mains socket (see
“3. Technical data” on page 65).
7. Add around 5 l water to the container 3.
8. Allow the water to boil for around 20
min (see “6. Operating the appliance”
on page 68).
9. Pour the water away.
The appliance is now ready to use.
6. Operating the appliance
6.1 Adjusting settings, switching on and
off
Note: As soon as you turn the rotary
knobs 7 or 6, the background illumination
for the displays will switch on automatically.
The light for the displays switches off again
automatically after 5 minutes.
Warning! Only connect the
appliance to an earthed mains
socket, as protection against
electric shock depends on this.
1. Insert the power supply plug in a
suitable earthed mains socket (see
“3. Technical data” on page 65).
2. Turn the rotary knob for the
temperature 6 to the temperature you
require.
– The temperature is increased in
increments of 1 °C;
– A signal sounds every 5 °C;
– The temperature selected is shown on
the display for temperature
selection 10.
RP89015 Einkochautomat LB1 Seite 68 Freitag, 22. Februar 2013 4:23 16