Silvercrest SKM 350 A1 - Manual (Page 51)

49 GB
6. Installation
DANGER! Risk of injury from
cutting!
~ The blade insert8, the grating disk5
and slicing insert4 are sharp. Handle
with care.
~ Only plug the mains plug14 into the
wall socket after the food processor has
been completely assembled.
NOTE: the device is equipped with a safe-
ty switch. The bowl11 can only be
locked with a closed lid3 and can only be
put into operation once it's locked.
1. Figure A: place the bowl11 on the mo-
tor block15. The symbol 16 points to
the bottom marking on the bowl12. Do
not turn the bowl.
2. Place the drive axle9 in the bowl.
3. Figure E: if required, place the slicing
insert4 / grating disk5 into the insert
holder6.
4. Place the dough blade7, the blade in-
sert8 or the insert holder6 with at-
tached slicing insert4 / grating disk5
on the drive axle9.
5. Dough blade7 / Blade insert8: Fill the
prepared foodstuffs into the bowl11,
as desired.
6. Figure A+B: place the lid3 on the
bowl11. The symbol 2 points to the
top marking on the bowl10.
7. Figure B+C: turn the lid3 in a clock-
wise direction as far as it will go, until
the symbol 2 points to the top mark-
ing on the bowl10.
8. Figures C+D: turn the bowl11 in a
clockwise direction as far as it will go,
until the symbol 16 points to the bot-
tom marking on the bowl12.
9. Insert the mains plug14 into a wall sock-
et corresponding to the technical data.
7. Operation
DANGER! Risk of injury from
cutting!
~ The insert holder6, the blade insert8
and the dough blade7 keep on turning
after the device has been turned off.
Please wait until all parts have come to
a standstill before unlocking the
bowl11 and opening the lid3.
~ The device must never be operated with-
out the bowl11.
WARNING! In order to prevent damage to
the device, interrupt the blending process im-
mediately if the insert holder6, the blade in-
sert8 and the dough blade7 are not turning
or are turning with difficulty. If this happens,
pull out the mains plug14 and check wheth-
er there is something in the bowl11 blocking
movement or whether the food is too tough.
Also check whether the device is assembled
correctly.
CAUTION: depending on the hardness and
consistency of the foodstuffs, do not fill the
bowl11 to the maximum, as the insert hold-
er6, the blade insert8 and the dough
blade7 could get blocked. Pay attention
here to the guideline values for various foods
in the "Processing table" section.
NOTE: for chopping harder foodstuffs, use
the setting P. Work with short pulses (1 pulse:
turn on P for approx. 1 second). The number
and length of the pulses will depend on the
quantity and consistency of the food.
__RP104067_B2.book Seite 49 Montag, 3. November 2014 11:26 11