Installation and assembly – MCZ Forma Wood 75 Dx - mod.2012 User Manual
Page 23
B
A
21
6-INSTALLATION AND ASSEMBLY
Technical Dept. - All rights reserved - Reproduction is prohibited
IMPORTANT!
The closed fireplace must be installed and connected to the flue duct exclusively by a specialised technician, in order
for all local or national regulations to be complied with. Installation must in any case be in accordance with UNI
10683.
When the closed fireplace is unpacked, check that every part is in perfect working order and no damage has been caused during transport.
Any damage must immediately be reported to the carrier or dealer.
If the closed fireplace is installed in a place that is difficult to access, the weight can be reduced by removing the internal elements of the
firebox, but it is recommended to put all elements back in place properly and have this operation carried out exclusively by specialised
personnel.
The manufacturer declines all liability if the warning above is not complied with.
PREPARATION AND UNPACKING
Open the package, remove the closed fireplace from the pallet and set it in the pre-selected place, making sure this complies with the
requirements.
The closed fireplace must always remain in a VERTICAL position and handled solely with a cart. Do not drag the unit
which could suffer damage to the support feet.
To remove the closed fireplace from the pallet act as follows:
• Remove plate A by removing the screws
• Remove the two screws from bracket B
One can then remove the 4 locking brackets "B", after having inserted the feet or wheels (supplied), raising them and tilting them slightly
to enable extraction. Pay particular attention to the door and its glass, protecting them from mechanical knocks that would compromise
their integrity.
Always handle the products with care. If possible, unpack the closed fireplace near the area
it will be installed in.
The packaging materials are neither toxic nor harmful, and therefore no particular disposal measures are required.
Storage, disposal or any recycling is under the responsibility of the end user in compliance with the applicable laws in force.
BLOCKING PLATES AND BRACKETS
EXAMPLE OF CLOSED FIREPLACE PACKAGE