MCZ Stripe Overnight - Manual (Page 31)

29
6-MAINTENANCE AND CLEANING
All the cleaning operations of all parts must be performed with a completely cold product.
CLEANING PERFORMED BY THE USER
CLEANING THE GLASS
The glass can be cleaned with specific products (see our price list), a cloth soaked in a water and ammonia solution or a little white ash and
a sheet of newspaper. It takes longer to clean if there is any soot build-up and dirt.
Do not spray the cleaning product on to the painted parts or the seals of the door (ceramic fibre cord).
The ceramic glass installed on the manufacturer’s products have a heat resistance of approximately 750°C and are
tested and checked before and after assembly to check for any cracks, bubbles and swelling.
Despite the high resistance to temperature, the glass is a fragile element and it is therefore recommended to handle
the door carefully without slamming or forcing it. The glass can break as it is not a flexible element.
Moreover, this type of glass does not shatter or burst and should it break, for the above reasons, only a crack will
form.
CLEANING THE UPPER CALORITE DEFLECTORS
They require no special care. Even though the internal deflectors of the combustion firebox are made of effective yet porous material, they
must be replaced after prolonged use due to wear, damage caused when their thickness is reduced to half or broken.
CLEANING THE ASH
This must be performed with the product turned off; it is recommended to thoroughly clean the ash pan to ensure correct combustion.
Open the door, remove the grille and the ash pan using the supplied cold handle.
Clean also any ash deposits in the pan compartment.
Hot ashes must be stored outside with utmost care and not thrown into the dustbin. Allow them to cool down in the open
air in a metal container.
Technical Dept. - All rights reserved - Reproduction is prohibited