Riello UPS Sentinel Dual (High Power) (3.3 - 10 kVA) - Manual (Page 52)

52
U
SE
Measurements display area
The most important measurements relating to the UPS may be displayed on the display screen.
When the UPS is switched on, the display shows the mains voltage value.
To move on to display something else, press the “SEL / SET” button repeatedly until the desired
measurement value appears.
If a failure/alarm occurs (FAULT) or the machine stops (LOCK), the display will automatically display the
type of problem and the corresponding alarm code.
A number of examples are shown below:
SAMPLE GRAPHIC
(1)
DESCRIPTION
Mains voltage
Mains frequency
UPS output voltage
Output voltage frequency
Remaining battery backup
Battery charge percentage
SAMPLE GRAPHIC
(1)
DESCRIPTION
Total battery voltage
Percentage load applied
Current absorbed by the
load
Temperature of the
cooling system of the
UPS internal electronics
Fault / Alarm (2) : the
corresponding code is
displayed
Lock (2) : the
corresponding code is
displayed
(1) The values given in the pictures of the table are purely indicative.
(2) The FAULT / LOCK codes will only be displayed if they are active at that time (in presence of a failure/alarm or
machine stoppage).