Rose Electronics VISTA L-SERIES - Manual (Page 22)

OPERATING INSTRUCTIONS
16 Vista L-Series Installation and Operations Manual
Keyboard commands (continued)
Command Key Sequence Description
Computer
disconnect. <Ctrl> L Disconnects from computer.
Scan (On) <Ctrl> S Turns scan mode on, causing the
Vista to start scanning
sequentially from the current port
through the remaining ports and
start again at Port 1.
Scan (Off) <Ctrl> X Turns scan mode off.
Reset mouse
command <Ctrl> O Sends reset mouse command to
the currently selected computer.
Will recover stuck NT mouse
Table 5. Keyboard commands
Use only the numeric keys above the keyboard. The keypad will not work.
All keyboard commands must be entered within 2 seconds of pressing and
releasing the left <Ctrl> key.
Keyboard command description
Computer select
To select a computer from your keyboard, press and release the left <Ctrl>
key and then type in the computer number (1-4 or 1-8).
Next computer
To switch to the “Next computer”, press and release the left <Ctrl> key,
then press the plus/equal key.
Previous computer
To switch to the “Previous computer”, press and release the left <Ctrl> key
then press the minus/underscore key.
Scan mode (On)
Follow each set-up command with the “Keep” command
to save the changes.
“Keep” command = press and release the left <Ctrl> key,
then the “K” key.