Rose Electronics UltraVista LC II - Manual (Page 21)

15 UltraVista LC II Installation and Operations Manual
1 x 1 This is the default mode. The video input is cloned on all the
monitors.
2 x 1 The video input is shown on the top two panels and repeated on
the bottom two. *
2 x 2 The video input is tiled over all the panels.
2 x 3 The video input is split across a six-panel array in a 2 x 3 setup. **
3 x 2 The video input is split across a six-panel array in a 3 x 2 setup. **
3 x 3 The video input is split across a nine-panel array in a 3 x 3 setup.
**
Mode 1 Same as 2 x 2, but the top left panel shows the full image. *
Mode 2 Same as 2 x 2, but the top right panel shows the full image. *
Mode 3 Same as 2 x 2, but the bottom left panel shows the full image. *
Mode 4 Same as 2 x 2, but the bottom right panel shows the full image. *
* VWL-B122FD only
** VWL-B133FD only
Table 3. Display modes