Rose Electronics CrystalView Mini USB - Manual (Page 16)

INSTALLATION
10
CRYSTALVIEW MINI USB INSTALLATION AND OPERATIONS MANUAL
Step 4 - Connect Local unit to Remote unit with CATx cable
Figure 5. Local to Remote unit
Connect up to 150’ of CAT5, CAT5e, CAT6, or CAT7 cable between the
RJ45 connector on the Local unit and the RJ45 connector on the Remote
unit. Two cables are required for dual video and/or serial and audio
models.
Note: CATx cable from RJ45 port #1 carries the primary video, keyboard,
and mouse signals.
CATx cable from RJ45 port #2 carries the secondary video, serial
and audio signals.
Step 5 – Apply power
Connect the power adapter to the Remote unit’s power jack. Apply power
to the monitors and computer. Power for the Local unit is obtained from
the computer’s USB ports. If only video is being transmitted and no USB
connections are made, a Local power adapter (optional) must be used.
With power applied to all units and devices, the Remote monitor should
display the computers video.