Rugged Cams Fusion DVR - Manual (Page 20)

4CH User Guide
1-3. Recording Configuration
This is for Motion, Alarm, Sensor Recording Setup.
Set recording schedule. If this menu item is selected, screen will change as shown
in figure 1.3.2
SCHEDULE
Enable/disable audio for the specified channel AUDIO
Set alarm time duration for the specified channel. ALARM DURATION
Enable/disable alarm generation for the specified channel. ALARM
Set post event recording time duration for the specified channel
POST EVENT
RECORD
Enable/disable pre-event recording. Pre-event recording time is 5 sec and only
intra-frames are recorded for pre-event recording.
PRE RECORD
Set the type of sensor for the specified channel from none,
N/O (normal open), and N/C (normal closed).
SENSOR TYPE
Set the motion sensitivity for the specified channel. Control th e motion sensitivity
from 1 to 9. MOTION
SENSITIVITY
Select Full Zone or Partial Zone for motion sensing. If the Partial Zone is selected,
screen will be change as shown in figure 1.3.1
MOTION ZONE
Assign the recording mode for each channel. Recording modes: Continuous,
Motion, Sensor, and Disable.
RECORDING
Select the recording quality for the specified channel from normal, high, and
superior.
QUALITY
Set the frame rate for the specified channel. The sum of the fra me rate values from
each channel cannot exceed maximum frame rates for a particular recording
resolution. Typical values of the maximum frame rate for NTSC video are
120/100fps for QUAD (360*240(NTSC)/360*288(PAL)) and 30/25 fps for FULL
(720*480(NTSC)/720*576(PAL)).
FRAME RATE
Select the channel for applying the following settings. CHANNEL
Set resolution to either full or quad. RESOLUTION
Description Manu item
[Table 1-3] Recording Menu Configuration
20