TA Triumph-Adler FAX 925 - Manual (Page 81)

English
Chapter 6 - Programming 73
15:INCOMING RING: This function controls the telephone ringing
sound your fax machine makes when a call comes in. When this function
is set to off, your fax machine will not ring during incoming calls. When
set to on, your fax machine only rings when set to manual receive mode
or 11:RING RESPONSE is set to 5 to 20 seconds (except 1 ring). When
set to DRC, your fax machine rings for each incoming call with the same
tone, even if you have function 12:DISTINCTIVE RING set to on.
Available settings are ON, OFF and DRC.
Note: DRC is only available if the setting of user function
12:DISTINCTIVE RING is available. Also, when set to OFF,
there is no effect on ringer in telephone/fax auto switch
answering mode.
16:REMOTE RECEIVE: When you receive an incoming call, this
function allows you to remotely tell your fax machine to switch from
telephone to fax mode to receive an incoming fax. To use this function,
use the keypad of a handset or an external telephone to enter the code
number of remote receive you have programmed into your fax machine.
Available settings are off, 00, 11, 22, 33, 44, 55, 66, 77, 88, 99, ** and ##.
This function only works if your telephone system is a tone dialling
system.
17:MEM./FEEDER SW.: This function controls how your fax machine
normally transmits fax messages to one location. Either scanning the
document into memory first and then start dialling, or by transmitting
directly from the document feeder after dialling. Available settings are
MEM. and FEED.
Note: The setting of 17:MEM./FEEDER SW. only becomes effective if
user function 25:INSTANT DIALLING is set to OFF. If
25:INSTANT DIALLING is set to ON, all documents are
scanned upon call origination.
18:POWER SAVE MODE: This function substantially reduces the
amount of power your fax machine consumes when it is not in use. When
this function is on, your fax machine automatically switches to power save
mode after it has been idle for three minutes. When this occurs, your
display shows POWER SAVE MODE PRESS “Start” to exit.
While in this mode, your fax machine automatically switches back to full
operation after you press the Start key, when the telephone rings, when the
telephone handset is lifted, or when a document is loaded. Available
settings are on and off.